<blockquote id="quote"><font size="1" face="Verdana, Arial, Helvetica" id="quote">Zitat:<hr height="1" noshade id="quote">Nur zur Sicherheit die Frage: R=2098 und D=300<hr height="1" noshade id="quote"></blockquote id="quote"></font id="quote">
Kurt...kleiner Hinweis: Ich lese da 2990mm als best fit radius of curvature... [:I] Das wäre etwas schneller als f/5 [;)]
Otto: ich würde immer _ohne_ FS arbeiten. Später, wenn der Spiegel als fertig deklariert wird, kann man den FS immer noch rein nehmen. Das Ergebnis wird nur besser dann.
Gruß
ullrich